RAID Format

Support and Discussion for HUR3-SU3S3 ProRaid - For PC Users

RAID Format

Postby keef » November 24th, 2018, 10:41 am

I am using two 1tb drives under raid 1. I installed them formatted as FAT-32. In Raid 1 Windows did not see the array. I tried to format them while installed and both drive lights are blinking, the drives make a little noise however it has been 10 minutes and the format shows no progress on the progress bar (EaseUS).

What are the steps to get this going? Do I format the drives first? NTFS, eFat or ????. The quick user manual leaves out so much.

I am stuck here.

thanks, Bj
keef
 
Posts: 1
Joined: October 11th, 2018, 12:26 pm

Return to HUR3-SU3S3 ProRaid - For PC Users

Who is online

Users browsing this forum: No registered users and 1 guest