Error message saying disk is not formatted

Support and Discussion for HUR3-SU3S3 ProRaid - For PC Users

Error message saying disk is not formatted

Postby rrogers44 » April 17th, 2019, 8:38 pm

Capture.PNG
Capture.PNG (5.63 KiB) Viewed 249 times

Capture 2.PNG
Capture 2.PNG (6.79 KiB) Viewed 249 times


Hello,

I have been using the enclosure for about 2 years in Raid 1. The other day I got an error message (attached) saying my disk needed to be formatted before use. Canceling resulted in an error message (attached) saying the disk was not accessible and that there was no recognizable file system. HDD1 light was flashing blue/red.

I purchased a new drive to replace HDD1. When I inserted it, the following happened: Rebuild light came on and red x next to HDD1 came on. Red/blue flash with rebuild light on for about 4 hours. Rebuild light went off and HDD1 and HDD2 lights were blue. Clicked on the drive in file manager and got the same issue.

What should my next steps be?

Thanks in advance for your help.

Rich
rrogers44
 
Posts: 1
Joined: April 13th, 2019, 10:33 pm

Re: Error message saying disk is not formatted

Postby Admin_Mediasonic » April 22nd, 2019, 11:45 pm

before you replaced HDD1
were you able to access the Raid array?
if you didn't them is possible both drives went bad or 1 drive went bag
and caused drive 2 to loose partition table? Did you check under disk management to see what you see there?

after rebuild finished has you turn off enclosure yet?
Admin_Mediasonic
Site Admin
 
Posts: 1782
Joined: January 28th, 2010, 3:29 pm


Return to HUR3-SU3S3 ProRaid - For PC Users

Who is online

Users browsing this forum: No registered users and 2 guests