Switch to Single from RAID 1 without data loss

Support and Discussion for HUR3-SU3S3 ProRaid - For PC Users
Post Reply
rrogers44
Posts: 2
Joined: April 13th, 2019, 10:33 pm

Switch to Single from RAID 1 without data loss

Post by rrogers44 »

I am getting a read error from my enclosure in RAID 1 mode. I suspect one of the drives is bad. Can i switch to Single using the mode button and keep data intact on each drive and then check the drives independently?

If so, any special steps when using the mode button?

Thanks,

Rich

Post Reply

Return to “HUR3-SU3S3 ProRaid - For PC Users”