Mediasonic HFR2-SU3S2 RAID 0,1,3,5,1+0 USB 3.0 & eSata

Support and Discussion for HFR2-SU3S2 ProRaid - For PC Users

Mediasonic HFR2-SU3S2 RAID 0,1,3,5,1+0 USB 3.0 & eSata

Postby Admin_Mediasonic » August 11th, 2010, 5:04 pm

Mediasonic HFR2-SU3S2 RAID 0,1,3,5,1+0 USB 3.0 & eSata
HFR2-SU3S2_01.JPG
HFR2-SU3S2_01.JPG (77.85 KiB) Viewed 11400 times
HFR2-SU3S2_02.JPG
HFR2-SU3S2_02.JPG (81.84 KiB) Viewed 11398 times
HFR2-SU3S2_03.JPG
HFR2-SU3S2_03.JPG (75.46 KiB) Viewed 11398 times
HFR2-SU3S2_04.JPG
HFR2-SU3S2_04.JPG (71.42 KiB) Viewed 11398 times
HFR2-SU3S2_05.JPG
HFR2-SU3S2_05.JPG (77.47 KiB) Viewed 11398 times
HFR2-SU3S2_06.JPG
HFR2-SU3S2_06.JPG (67.54 KiB) Viewed 11397 times
Admin_Mediasonic
Site Admin
 
Posts: 1750
Joined: January 28th, 2010, 3:29 pm

Moving Set of Raid drives from Old unit to new Unit

Postby Admin_Mediasonic » December 13th, 2010, 3:44 pm

For HFR2-SU3S2, in the event that the unit dies or becomes defective. When you get or buy a replacement (same model). Here is the proper way to put the Old set of RAID Hard Drives back to the New unit.

1. Connect the new unit to a computer WITHOUT any hard drive in it.
2. Set the same Raid mode as you had before. And press on he Raid confirmation button, until unit turns off
3. Put in the old set of Raid Hard drive in the new unit in the same order as you had before.
Admin_Mediasonic
Site Admin
 
Posts: 1750
Joined: January 28th, 2010, 3:29 pm

Set up Info

Postby Admin_Mediasonic » December 13th, 2010, 3:50 pm

After you installed the hard drives

Make sure 4 Bay is connected to a computer that is turned on
Power on the device and press Mode button on the front of the unit for 3 seconds until LED flashes. Press it again to select the RAID mode you want then press the Confirmation button on the back panel until the device shuts down. Power on the device again and the RAID mode set-up is completed.
Admin_Mediasonic
Site Admin
 
Posts: 1750
Joined: January 28th, 2010, 3:29 pm


Return to HFR2-SU3S2 ProRaid - For PC Users

Who is online

Users browsing this forum: No registered users and 1 guest