Page 1 of 1

Moving Raid Array to new enclosure

PostPosted: May 16th, 2019, 12:41 pm
by Gabeg
Can I move a raid3 array from the HFR2-SU3S2 to a HFR7-SU3S2?

Re: Moving Raid Array to new enclosure

PostPosted: May 23rd, 2019, 7:43 pm
by Admin_Mediasonic
As long as the Raid 3 is currently accessible and it is not Raid array corruption
but you need to set up HFR7 with these steps

1. Connect the new unit to a computer WITHOUT any hard drive in it.
2. Turn the unit on and set the same Raid mode as you had before. And press on the Raid confirmation button, until unit turns off
3. Turn the unit ON, WITHOUT any hard drive in it. (important) verify raid was set correctly.
4. Put in the old set of Raid Hard drive in the new unit in the same order as you had before. (While unit is ON from step 3)
5. Wait for the unit to recognize the old Raid setting