Page 1 of 1

HFR2-SU3S2FW,Raid 0/1/3/5/10, USB 3.0,eSata,Firewire 400/800

PostPosted: December 30th, 2010, 6:02 pm
by Admin_Mediasonic
Mediasonic HFR2-SU3S2FW, Raid 0/1/3/5/10, USB 3.0, eSata, firewire 400 & 800

HFR2-SU3S2FW.jpg
HFR2-SU3S2FW.jpg (61.98 KiB) Viewed 13730 times

Set up Info

PostPosted: September 5th, 2011, 2:00 am
by Admin_Mediasonic
After you installed the hard drives

Make sure 4 Bay is connected to a computer that is turned on
Power on the device and press Mode button on the front of the unit for 3 seconds until LED flashes. Press it again to select the RAID mode you want then press the Confirmation button on the back panel until the device shuts down. Power on the device again and the RAID mode set-up is completed.