Page 1 of 1

Mediasonic HFR2-SU3S2 RAID 0,1,3,5,1+0 USB 3.0 & eSata

PostPosted: August 11th, 2010, 5:04 pm
by Admin_Mediasonic
Mediasonic HFR2-SU3S2 RAID 0,1,3,5,1+0 USB 3.0 & eSata
HFR2-SU3S2_01.JPG
HFR2-SU3S2_01.JPG (77.85 KiB) Viewed 16314 times
HFR2-SU3S2_02.JPG
HFR2-SU3S2_02.JPG (81.84 KiB) Viewed 16312 times
HFR2-SU3S2_03.JPG
HFR2-SU3S2_03.JPG (75.46 KiB) Viewed 16312 times
HFR2-SU3S2_04.JPG
HFR2-SU3S2_04.JPG (71.42 KiB) Viewed 16312 times
HFR2-SU3S2_05.JPG
HFR2-SU3S2_05.JPG (77.47 KiB) Viewed 16312 times
HFR2-SU3S2_06.JPG
HFR2-SU3S2_06.JPG (67.54 KiB) Viewed 16311 times

Moving Set of Raid drives from Old unit to new Unit

PostPosted: December 13th, 2010, 3:44 pm
by Admin_Mediasonic
For HFR2-SU3S2, in the event that the unit dies or becomes defective. When you get or buy a replacement (same model). Here is the proper way to put the Old set of RAID Hard Drives back to the New unit.

1. Connect the new unit to a computer WITHOUT any hard drive in it.
2. Set the same Raid mode as you had before. And press on he Raid confirmation button, until unit turns off
3. Put in the old set of Raid Hard drive in the new unit in the same order as you had before.

Set up Info

PostPosted: December 13th, 2010, 3:50 pm
by Admin_Mediasonic
After you installed the hard drives

Make sure 4 Bay is connected to a computer that is turned on
Power on the device and press Mode button on the front of the unit for 3 seconds until LED flashes. Press it again to select the RAID mode you want then press the Confirmation button on the back panel until the device shuts down. Power on the device again and the RAID mode set-up is completed.