Page 1 of 1

SPN+ and 0+ Non Functional

PostPosted: February 19th, 2019, 2:16 pm
by ladron87
I have a model H8R2-SU3S2 Rev 4 and i would prefer that it be used in the SPN+ mode, however anytime i attempt to set this mode the unit powers on and after about 10 seconds the HDD error light comes on.
This does not occur if I have the modes 2xSPN+ or 2x0+ applied. only with SPN+ or 0+
I have tested the drives separately and they both function. They are in slots 1 and 5.
Looking at the documentation it lists examples of 4 drives, I am wondering if I need 4 and not just 2 to apply SPN+.

Any suggestions?

Re: SPN+ and 0+ Non Functional

PostPosted: March 3rd, 2019, 1:22 am
by ladron87
Going to 4 drives allowed the unit to function.