Mediasonic HFR2-SU3S2 RAID 0,1,3,5,1+0 USB 3.0 & eSata

[Admin_Mediasonic]

Mediasonic HFR2-SU3S2 RAID 0,1,3,5,1+0 USB 3.0 & eSata

HFR2-SU3S2_01.JPG (77.85 KiB) Viewed 16317 times

HFR2-SU3S2_02.JPG (81.84 KiB) Viewed 16315 times

HFR2-SU3S2_03.JPG (75.46 KiB) Viewed 16315 times

HFR2-SU3S2_04.JPG (71.42 KiB) Viewed 16315 times

HFR2-SU3S2_05.JPG (77.47 KiB) Viewed 16315 times

HFR2-SU3S2_06.JPG (67.54 KiB) Viewed 16314 times

[Admin_Mediasonic]

For HFR2-SU3S2, in the event that the unit dies or becomes defective. When you get or buy a replacement (same model). Here is the proper way to put the Old set of RAID Hard Drives back to the New unit.

1. Connect the new unit to a computer WITHOUT any hard drive in it.
2. Set the same Raid mode as you had before. And press on he Raid confirmation button, until unit turns off
3. Put in the old set of Raid Hard drive in the new unit in the same order as you had before.

[Admin_Mediasonic]

After you installed the hard drives

Make sure 4 Bay is connected to a computer that is turned on
Power on the device and press Mode button on the front of the unit for 3 seconds until LED flashes. Press it again to select the RAID mode you want then press the Confirmation button on the back panel until the device shuts down. Power on the device again and the RAID mode set-up is completed.