Can this unit be configured as 4 disk jbod with each disk *individually* visible in windows (10)? I don't want to use raid or spanning at this time.
I bought this unit to have the *optional* RAID, but currently just want to configure as 4 individual disks.
Is there any way to do this, or is it a hardware limitation???
Thank-you!
JBOD non-RAID, non-Spanning for now...!?
4 posts
• Page 1 of 1
JBOD non-RAID, non-Spanning for now...!?
by CosmicPuppy » December 31st, 2015, 8:04 pm
- CosmicPuppy
- Posts: 1
- Joined: December 31st, 2015, 7:56 pm
Re: JBOD non-RAID, non-Spanning for now...!?
by Hisen » January 13th, 2016, 11:07 pm
I tried. You just preset the system as "single mode", then all disks can be seen individually in windows 10.
However, you cannot eject only ONE disk. You have to eject all disks when you want to disconnect any disk.
However, you cannot eject only ONE disk. You have to eject all disks when you want to disconnect any disk.
- Hisen
- Posts: 3
- Joined: December 27th, 2015, 1:14 pm
Re: JBOD non-RAID, non-Spanning for now...!?
by Admin_Mediasonic » January 19th, 2016, 3:45 pm
- Admin_Mediasonic
- Site Admin
- Posts: 1807
- Joined: January 28th, 2010, 3:29 pm
Re: JBOD non-RAID, non-Spanning for now...!?
by Raidnovice » February 26th, 2018, 1:09 am
- Raidnovice
- Posts: 2
- Joined: February 26th, 2018, 1:08 am
4 posts
• Page 1 of 1
Return to HFR2-SU3S2 ProRaid - For PC Users
Who is online
Users browsing this forum: No registered users and 0 guests